Tampermonkey will open automatically and ask you to confirm.
After installing, you'll see UltraVPB listed in your Tampermonkey dashboard with a green toggle.
3 You're Ready
✓
UltraVPB is set up!
Open any VAN phone bank and look for the UltraVPB panel with a QR code.
Quick Start
Open a phone bank on your laptop (VAN, EveryAction, or OpenVPB)
Look for the UltraVPB QR code in the sidebar
Scan the QR code with your phone's camera
Your phone shows each voter's info with a tap-to-dial button
After the call, tap a result code on your phone — it marks it on VAN automatically
Works with: VAN / EveryAction · OpenVPB · BlueVote
iPhone tip: After scanning the QR code, tap Share → Add to Home Screen to make UltraVPB feel like a native app on your phone.
Troubleshooting
I don't see a QR code on my phone bank page
Check that Tampermonkey is enabled (you should see its icon in your browser toolbar with a small number badge). Also make sure you're on a supported phone bank page — the URL should contain openvpb.com, everyaction.com, or bluevote.com. Try refreshing the page.
My phone says "Connecting..." and nothing happens
Refresh the VAN page on your laptop to generate a fresh QR code, then scan it again. If you're on a slow network, give it a few seconds — the phone will automatically fall back to a different connection method.
The QR code won't scan
Try tapping the link that appears below the QR code on your laptop instead — you can also type it into your phone's browser. Make sure your phone camera is close enough and the screen is bright.
It was working but now my phone shows "Host disconnected"
This means the VAN page on your laptop was closed or refreshed. Reopen your phone bank on the laptop, then scan the new QR code.